NA is a bit hard. Im sure anyone doing that has a stroker.
I built a Jackson Racing Supercharged one that made about 290 whp. Thats your 300-400 right there. Supercharger and a few bolt ons. It worked. And pulled on C5 vettes.
Will be a nice build either way.
K20A fully Built
-
Bahrain Type R
- UB Addicted Member
- Posts:108
- Joined:07 Sep 2010, 5:08 pm
- Vehicle:Honda Civic Type R ep3
- Location:Bahrain
- Contact:
Back Again
Finally Got Dyno'd without a k-pro and had on run on Track
233 HP on flywheel .. 204 on Wheels ,, which is really good for almost a stock Car ( intake + headers + exhaust + Throttle ) and that's it
my Future mods are gonna Be ( K-pro + Skunk2 Cams + Pistons + intake manifold + k24 Block
and After That i will see how much i'm getting on Wheels and then i'm going for a SuperCharger )
on track i got 13.6 without weight removal and without Slicks
i'm hoping for 11 seconds inshalla
Finally Got Dyno'd without a k-pro and had on run on Track
233 HP on flywheel .. 204 on Wheels ,, which is really good for almost a stock Car ( intake + headers + exhaust + Throttle ) and that's it
my Future mods are gonna Be ( K-pro + Skunk2 Cams + Pistons + intake manifold + k24 Block
and After That i will see how much i'm getting on Wheels and then i'm going for a SuperCharger )on track i got 13.6 without weight removal and without Slicks
i'm hoping for 11 seconds inshalla
it is possible on k24 block (if atmo)Bahrain Type R wrote:hello boys
i wanna build my k20A to reach for 300 - 400 HP with N\A
any suggestions ,, mods or even the cost
This dinorun of this spec:
Cp pistons 11.5 87.5 mm
BrainCrower connecting rod
Bearings ACL Racing
ARP studs
K20A red (type-r) head
Porting, RBC, throttle 70mm BDL
BrainCrower +0.5 valves
BrainCrower camshaft Stage 2
BrainCrower springs
BrainCrower titans retainer
you may change 11.5 on 12,5 and use ITB with stage 3 cams for more than 350hp
-
Bahrain Type R
- UB Addicted Member
- Posts:108
- Joined:07 Sep 2010, 5:08 pm
- Vehicle:Honda Civic Type R ep3
- Location:Bahrain
- Contact:
Back for some action
if everything went fine, my car should be ready for action by the end of august or mid september.
new exterior look ( championship white + mugen front lip + wing + new headlights 2002 model, mine are messed up ) and engine ( k20A + k24 + full block Build + hondata + skunk2 Throttle and intake manifold ) and will see what else does my baby girl needs 
if everything went fine, my car should be ready for action by the end of august or mid september.
new exterior look ( championship white + mugen front lip + wing + new headlights 2002 model, mine are messed up ) and engine ( k20A + k24
+ full block Build + hondata + skunk2 Throttle and intake manifold ) and will see what else does my baby girl needs